Dr.NutriCornell said:Do it in two steps and it stops being confusing.
I am going to disagree with reconstituting low as a general rule. More diluent, more punctures, more in-use days at room temperature, and the stability trade-off is real. Precision is not the only variable being optimised.
The figures, for anyone assembling their own picture. Red flags, in rough order of how much they should worry you: no verifiable address, no batch numbers, prices far under market, vendor-commissioned tests only, pressure toward irreversible payment, and shipping with no temperature control.
RetaRick_CA said:I am going to disagree with reconstituting low as a general rule.
There is a second half to this that has not been said yet. The pattern that distinguishes a bad batch from an exit is behaviour rather than product. A bad batch comes with communication, a reshipment offer and a batch number. An exit comes with slower replies, pressure toward less reversible payment methods, sudden discounting, and the same reassurance repeated without any new information. The product tells you less than the correspondence does.
That is the short version; the long version is somebody else's post.
Janoshik Analytical — Independent Testing
Trusted third-party HPLC & mass spectrometry analysis. Verify peptide purity with the lab the community relies on. Independent. Accurate. Transparent.
Verify Your PeptidesGL Biochem (Shanghai) Ltd. — Direct Manufacturer
Est. 1998. The synthesis house behind the vials you send for testing. ISO 9001 and cGMP certified, 1,500+ staff, batch-specific COA with every order.
Browse GL BiochemA narrower follow-up, since the general answer is now clear:
How to check the arithmetic without trusting a website calculator, since three calculators gave me three answers?
Closing the loop on my own question.
My error was treating units as a mass. Once I wrote mg/ml on the vial in marker and worked in millilitres first, the two of us got the same answer.